I am trying to run my new Flowkit in FC7 on a PIC32 ,so far I was not very successful,
Please help me understand how to use it in FC7 ,
I am reading the Flowkit manual with my efforts however the manual is based on FC6 and as you will see below in my questions it differs from FC7 it seems at least to me at this point
![Embarassed :oops:](./images/smilies/icon_redface.gif)
(1) I have installed the drivers as per manual and I can see FlowkitV2 in hardware manager under Custom USB devices
(2) I then place a scope component as the manual advise on page 6 and configure Trace 0 as RB3
(3) I then compile and program the PIC32
(4) I click the Ghost button and I get a Popup window which shows me ICD and port Monitor Scope
(5) I click OK and the ghost button goes green
now on Page 7 the manual instruct to go to debug and select Monitor or ICD which I do not find this selection when I click on the debug menu ?
please help me with a simple setup in FC 7 to read a Digital pin on D0 and 1 Analog pin on Flowkit for the moment to get started with Flowkit,
I received my Flowkit today and I am very excited to use it almost 1 year I want one and now I have it I am so happy