Communication issues??
Moderator: Benj
-
- Posts: 122
- Joined: Thu Jun 26, 2014 12:01 pm
- Has thanked: 41 times
- Been thanked: 19 times
- Contact:
Communication issues??
It is possible to run a program using I2C and SPI communication components simultaneously?
-
- Valued Contributor
- Posts: 2045
- Joined: Wed Aug 27, 2008 10:31 pm
- Location: Netherlands
- Has thanked: 553 times
- Been thanked: 1081 times
- Contact:
Re: Communication issues??
Yes/it depends/no.
There is no generic answer to this question as it depends on the controller being used. So if you want an answer you need to be more specific. Also, do you require hardware I2C & SPI or would software implementations work?
There is no generic answer to this question as it depends on the controller being used. So if you want an answer you need to be more specific. Also, do you require hardware I2C & SPI or would software implementations work?
“Integrity is doing the right thing, even when no one is watching.”
― C.S. Lewis
― C.S. Lewis
-
- Posts: 122
- Joined: Thu Jun 26, 2014 12:01 pm
- Has thanked: 41 times
- Been thanked: 19 times
- Contact:
Re: Communication issues??
I'm using the arduino mega for my project. The issue is that I got a program which uses the I2C clock and also The SPI max 6675 in another section of my program. Even when I got both programs working individually, after merging both of them into a single one, the SPI does not seem to work. I'm not saying that I did not make a mistake but I can't see it. That's why I'm trying to find out if is possible or not.
-
- Posts: 122
- Joined: Thu Jun 26, 2014 12:01 pm
- Has thanked: 41 times
- Been thanked: 19 times
- Contact:
Re: Communication issues??
I found my mistake. Yes it is possible to have this two communications working. I don't know if at the same time but in my program they are separate.