Zigbee Application Guide

Introduction

These examples demonstrate the use of the Flowcode Zigbee component.

In particular they make use of up to three sets of the EB051 E-blocks Zigbee boards, connected to EB006 E-blocks PICmicro multiprogrammers fitted with a 16F1937 microprocessor.

However, the examples are easily changed in Flowcode to support other microprocessors and platforms.

The Matrix TSL EB421SI6 Easy Zigbee bundle has all the items required for these sample applications and is an ideal introduction to Zigbee technology.

Setting up the project hardware

Connect the E-Blocks as indicated in the table below.

The Zigbee, LCD and Switch E-Blocks all need to be powered via wire connections to the +V on their respective EB006 upstream processor board.

Hardware Setup (Node 1 - Coordinator)

	EB006	PICmicro multiprogrammer
Port A
Port B	EB005	E-blocks LCD board
Port C	EB051C	E-blocks Zigbee board
Port D

Hardware Setup (Node 2 - End Node)

	EB006	PICmicro multiprogrammer
Port A
Port B
Port C	EB051R	E-blocks Zigbee board
Port D	EB007	E-blocks switch board

Hardware Setup (Node 3 - End Node)

	EB006	PICmicro multiprogrammer
Port A
Port B	EB004	E-blocks LED board
Port C	EB051R	E-blocks Zigbee board
Port D

Example 1: Simple two node connection example

Simple Two Node Connection Example (Node 1) Simple Two Node Connection Example (Node 2)

Example 1 is a simple 2 node system. The Coordinator node 1 starts up the network and then checks to see if node 2 is available. Once node 2 has been detected any incoming data from node 2 is displayed on the LCD display. The data on node 2 is specified by pressing a switch on the switch E-Block connected to Port D.

Example 2: Three node data transfer example

Three Node Data Transfer Example (Node 1) Three Node Data Transfer Example (Node 2) Three Node Data Transfer Example (Node 3)

In example 2 we will connect all 3 of the multiprogrammer boards to the Zigbee network. The Coordinator node will start up the network and then check that all nodes are present. Once all of the nodes have been successfully discovered the program then sends out a 0 which triggers the end nodes to start their main functionality. That is to send the switch data from node 2 to the LED board on node 3.