Using Labview to send data to PIc Micro

For Flowcode users to discuss projects, flowcharts, and any other issues related to Flowcode 6.

Moderator: Benj

Post Reply
jack26
Posts: 23
Joined: Sun Oct 09, 2011 4:38 pm
Has thanked: 4 times
Been thanked: 2 times
Contact:
Contact jack26

Using Labview to send data to PIc Micro

Post by jack26 »

Using Labview to read the data being sent from Pic 16F877, 5 Analogue channels and 18 Digital which all work fine. However I cannot get the LCD display on 'Development Board Ver3' to display the data sent from Labview.

Labview program is sending the data as a string and the Flowcode program is set to read the data as a string. Is there some specific character that has to be sent for the program on PIC to recognise the data being sent?

I have used scope to check the micro RX pin and data is present on it.

Thanks

Jack
Top
Post Reply

Return to “Flowcode V6”