Hi, does anybody know what I may be doing wrong here please,
basically on the panel I am adding an image of some brushed Aluminium and setting it to stretch so that it covers the panel area, then I set the panel grid show to false and the grid disappears, Wow that all looks great, so run the program and stop it , Oh the grid is back, is there any way of keeping the grid off or is this a bug ?...
thanks
Acestu
Flowcode version 5.5.2.1
Panel Grid Show True/False
Moderator: Benj
- acestu
- Posts: 1720
- Joined: Thu Dec 01, 2011 9:36 pm
- Location: Macclesfield UK
- Has thanked: 783 times
- Been thanked: 223 times
- Contact:
Panel Grid Show True/False
Laptop Mac Book Pro i7 retina El Capitan //// Tower/Intel i7-Windows 7 64 Bit, Toshiba i5 Laptop Windows 10
Computers are like air conditioners. They work fine until you start opening windows.
Computers are like air conditioners. They work fine until you start opening windows.
- Benj
- Matrix Staff
- Posts: 15312
- Joined: Mon Oct 16, 2006 10:48 am
- Location: Matrix TS Ltd
- Has thanked: 4803 times
- Been thanked: 4314 times
- Contact:
Re: Panel Grid Show True/False
Hello,
Yes it looks like this is a bug.
One thing you can do is set the grid size to something massive and switch off snap to grid. This way when the grid gets re-enabled you should only see a pixel or two out of place. Luckily the snap and the size don't seem to have the same reset issue on simulation end.
Yes it looks like this is a bug.
One thing you can do is set the grid size to something massive and switch off snap to grid. This way when the grid gets re-enabled you should only see a pixel or two out of place. Luckily the snap and the size don't seem to have the same reset issue on simulation end.
Regards Ben Rowland - MatrixTSL
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel