Hi guys
I am experiencing a problem with a V6 flowchart that I have created to control a domestic fridge. The problem being that when I step through my flowchart, the program and the slide switch, which simulates my external defrost timer switching "on", works perfectly well, however, when I run the program on the simulator, the slide switch does not work at all! I have tried everything to make it work so now I am not sure whether the simulator or I am the problem??
The delays in the program are just shortened to be able to speed things up until it works properly.
Please can some kind experienced soul check the attached flowchart for me? I have gained tremendous experience with Flowcode V6 already but this one has me beat, maybe just a mental blockage!!?
Thank you
Regards
Ted
Flowcode V6 Simulator
Moderator: Benj
-
- Matrix Staff
- Posts: 9521
- Joined: Sat May 05, 2007 2:27 pm
- Location: Northamptonshire, UK
- Has thanked: 2585 times
- Been thanked: 3815 times
- Contact:
Re: Flowcode V6 Simulator
Hi Ted,
You don't need both input icon and ReadState.
So either can be removed.
The reason simulation is not working is because you have got the switch and LCD pin on the same Port B4 connection.
On hardware not a good idea, unless limiting resistors are used as if LCD pin4 is low to send a char wihle switch is being pressed then microcontroller will get damaged.
If you change the switch connection to a port C pin then flowchart simulation should work.
Martin
You don't need both input icon and ReadState.
So either can be removed.
The reason simulation is not working is because you have got the switch and LCD pin on the same Port B4 connection.
On hardware not a good idea, unless limiting resistors are used as if LCD pin4 is low to send a char wihle switch is being pressed then microcontroller will get damaged.
If you change the switch connection to a port C pin then flowchart simulation should work.
Martin
Martin
-
- Posts: 79
- Joined: Sat Mar 14, 2015 7:52 am
- Has thanked: 46 times
- Been thanked: 26 times
- Contact:
Re: Flowcode V6 Simulator
Thanks Martin......I picked it up when I tried to run the program on the breadboard......duuuuuuu!!
I forgot to change the pin configuration on the LCD.
I am getting old now!!
Go well!
Regards
Ted
I forgot to change the pin configuration on the LCD.
I am getting old now!!
Go well!
Regards
Ted