I again.
I have had great trouble getting 16F628A to work.
But as I got for me to look a little extra on the PPP and I noticed that my changes did not come down to the chip.
So I tested this and did it well.
When I programerar chip, so I use pickit 2 and not pickit2 by Flow Code.
A bit difficult for me to explain.
So I did some pictures showing how I do to get the chip working.
It seems that flow code not loading my changes I make in the PPP.
Or am I wrong again
Foppa
lcd how to do
Re: lcd how to do
- Attachments
-
- ppp1.JPG (66.75 KiB) Viewed 3384 times
-
- ppp2.JPG (113.85 KiB) Viewed 3382 times
-
- pp3.JPG
- (82.95 KiB) Downloaded 1142 times
- Benj
- Matrix Staff
- Posts: 15312
- Joined: Mon Oct 16, 2006 10:48 am
- Location: Matrix TS Ltd
- Has thanked: 4803 times
- Been thanked: 4314 times
- Contact:
Re: lcd how to do
Hello
PPP runs in a few different modes. If you run PPP externally from Flowcode then it will not change the PPP used by Flowcode etc. To change the PPP settings from within Flowcode use the Chip -> Configure menu. You can then click the options button from here if you need to edit the programming options from within Flowcode.
PPP runs in a few different modes. If you run PPP externally from Flowcode then it will not change the PPP used by Flowcode etc. To change the PPP settings from within Flowcode use the Chip -> Configure menu. You can then click the options button from here if you need to edit the programming options from within Flowcode.
Regards Ben Rowland - MatrixTSL
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Re: lcd how to do
Hello Benj
To change the PPP settings from within Flowcode use the Chip -> Configure menu. You can then click the options button from here if you need to edit the programming options from within Flowcode.
It is just so I can not find on the options button "Chip -> Configure menu ->options "
foppa
To change the PPP settings from within Flowcode use the Chip -> Configure menu. You can then click the options button from here if you need to edit the programming options from within Flowcode.
It is just so I can not find on the options button "Chip -> Configure menu ->options "
foppa
-
- Valued Contributor
- Posts: 548
- Joined: Tue Jun 26, 2007 11:23 am
- Has thanked: 6 times
- Been thanked: 44 times
- Contact:
Re: lcd how to do
The path to the Flowcode programmer settings should have read 'Chip->Compiler Options...'
The programmer settings are then available on the Compiler Options panel.
The programmer settings are then available on the Compiler Options panel.