Matrix user forums

Posted: **Tue Apr 13, 2021 4:31 pm**

Running Flowcode 8 emulator on PIC16F18855 I observed that:
1) Changes on EEPROM InitialValues property does not take effect on emulator.
2) Changes on Switch (Slide,PCB) polarity property does not take effect on emulator.

Does not matter if I recompile or not.

The only way the change take effect is closing and reopening the program.

Can you please check it?

BEst regards,

Fernando

Posted: **Wed Apr 14, 2021 9:44 am**

Hello Fernando,

Please can you post a project that demonstrates these problems and I will investigate for you. The changes on both of those properties should be immediate and not require a reload of the project.

Matrix user forums

Property changes requires exit to be effective

Property changes requires exit to be effective

Re: Property changes requires exit to be effective