Running Flowcode 8 emulator on PIC16F18855 I observed that:
1) Changes on EEPROM InitialValues property does not take effect on emulator.
2) Changes on Switch (Slide,PCB) polarity property does not take effect on emulator.
Does not matter if I recompile or not.
The only way the change take effect is closing and reopening the program.
Can you please check it?
BEst regards,
Fernando
Property changes requires exit to be effective
Moderator: Benj
- Benj
- Matrix Staff
- Posts: 15312
- Joined: Mon Oct 16, 2006 10:48 am
- Location: Matrix TS Ltd
- Has thanked: 4803 times
- Been thanked: 4314 times
- Contact:
Re: Property changes requires exit to be effective
Hello Fernando,
Please can you post a project that demonstrates these problems and I will investigate for you. The changes on both of those properties should be immediate and not require a reload of the project.
Please can you post a project that demonstrates these problems and I will investigate for you. The changes on both of those properties should be immediate and not require a reload of the project.
Regards Ben Rowland - MatrixTSL
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel