Clock setting

Moderator: Benj

Post Reply
mnf
Valued Contributor
Valued Contributor
Posts: 1188
Joined: Wed May 31, 2017 11:57 am
Has thanked: 70 times
Been thanked: 439 times
Contact:

Clock setting

Post by mnf »

A visual bug.

Using an ATTiny MCU (I tried 88 and 22 others maybe affected too) - set the clock speed to > max speed (so for I tried 16 and 32MHz) - this (correctly) says 'greater than max speed' - but then displays the 'loading targets' with whirly. This stays until clicking 'cancel' which gets rid of it and no harm done..

Martin

User avatar
Benj
Matrix Staff
Posts: 15312
Joined: Mon Oct 16, 2006 10:48 am
Location: Matrix TS Ltd
Has thanked: 4803 times
Been thanked: 4314 times
Contact:

Re: Clock setting

Post by Benj »

Hi Martin,

Thanks for letting us know, that's certainly a strange one. I'll pass this onto Steve so he is aware of it.

User avatar
Steve
Matrix Staff
Posts: 3418
Joined: Tue Jan 03, 2006 3:59 pm
Has thanked: 114 times
Been thanked: 422 times
Contact:

Re: Clock setting

Post by Steve »

Hi Martin,

Thanks for identifying this glitch. I've checked Flowcode v9 and this problem doesn't happen there. I've also identified what's happening in the code for v8, but I'm not going to fix it as it's a minor issue that doesn't cause any other problems.

Regards,
Steve.

mnf
Valued Contributor
Valued Contributor
Posts: 1188
Joined: Wed May 31, 2017 11:57 am
Has thanked: 70 times
Been thanked: 439 times
Contact:

Re: Clock setting

Post by mnf »

Thanks, yes it didn't seem to cause a problem - and gone in v9...

Martin

Post Reply