Matrix user forums

We recently installed FC8 and all seems to work ok but the download to the FC Buggy fails. The two Buggy LEDs flash as expected suggesting the USB drivers are correctly installed but mLoader reports no target device attached even after the Buggy is reset. I ran the Buggyprog application from the FC8 Tools folder to check whether the Buggy is correctly connected and all reports OK. I'm not sure what else to try so any suggestions how to resolve this issue would be gratefully received.

Hello,

Please can you post your Flowcode project, it may be there is something simple like you have the raw PIC IC selected as your target rather than the specific robot definition file available from the Misc category.