Not sure if intended, but i like the idea of dragging a Macro Tab outside of Flowcode.
Unfortunately if want to dock back in flowcode, there are no docking arrows.
Just like there is if dragging 3D System panel in out of Flowcode.
If Main is dragged outside of Flowcode, then click on new, Flowcode will stop functioning.
Won't even allow close.
Requires use of Task Manager
Martin
Dragging Macro's outside of Flowcode
Moderator: Benj
-
- Matrix Staff
- Posts: 9520
- Joined: Sat May 05, 2007 2:27 pm
- Location: Northamptonshire, UK
- Has thanked: 2585 times
- Been thanked: 3815 times
- Contact:
-
- Posts: 62
- Joined: Mon Oct 23, 2017 9:54 am
- Has thanked: 11 times
- Been thanked: 22 times
- Contact:
Re: Dragging Macro's outside of Flowcode
Thanks Martin,
This appears to occur whenever all of your non-Start-page tabs are detached.
It is on the list of fixes for the next release
Regards,
Daniel
This appears to occur whenever all of your non-Start-page tabs are detached.
It is on the list of fixes for the next release
Regards,
Daniel