Dragging Macro's outside of Flowcode

[medelec35]

Not sure if intended, but i like the idea of dragging a Macro Tab outside of Flowcode.
Unfortunately if want to dock back in flowcode, there are no docking arrows.
Just like there is if dragging 3D System panel in out of Flowcode.

If Main is dragged outside of Flowcode, then click on new, Flowcode will stop functioning.
Won't even allow close.
Requires use of Task Manager

Martin

[DanielM]

Thanks Martin,

This appears to occur whenever all of your non-Start-page tabs are detached.

It is on the list of fixes for the next release

Regards,

Daniel