RFM95W Lora Modules
Posted: Fri Sep 01, 2023 7:56 pm
Hello
I'm working on making two RFM95W 868 Mhz Lora modules exchange data. Short distance, side by side first.
I went through all the registry settings and configured the macros based on the FC Lora component framework.
The register values are similar but not all, so I let the annotations on every one. RFM95W uses the SX1276 for notice.
Without any success so far, as there is only one lora module available in FC (even in V10), any help is greatly appreciated! It shouldn't be too far off to work but I can't find the necessary details anymore.
The macros to setup the frequency, read register and write register are working ok. Confirmed via LCD. So no problem with connections or SPI.
I hope someone from the MM team will take a look at it because it is a cheap component and many can bennefit from it.
It's not possible to use Lora modules without the Rx and Tx Switches? If it is, what are the configs necessary to setup this work mode?
Thanks!
I'm working on making two RFM95W 868 Mhz Lora modules exchange data. Short distance, side by side first.
I went through all the registry settings and configured the macros based on the FC Lora component framework.
The register values are similar but not all, so I let the annotations on every one. RFM95W uses the SX1276 for notice.
Without any success so far, as there is only one lora module available in FC (even in V10), any help is greatly appreciated! It shouldn't be too far off to work but I can't find the necessary details anymore.
The macros to setup the frequency, read register and write register are working ok. Confirmed via LCD. So no problem with connections or SPI.
I hope someone from the MM team will take a look at it because it is a cheap component and many can bennefit from it.
It's not possible to use Lora modules without the Rx and Tx Switches? If it is, what are the configs necessary to setup this work mode?
Thanks!