Mosfet Driver
Moderator: Benj
-
- Posts: 348
- Joined: Mon Jul 09, 2018 12:43 pm
- Has thanked: 67 times
- Been thanked: 33 times
- Contact:
Mosfet Driver
Hi everyone, how are you, hope you are all doing well. I would like to use the IR2104 ic to drive two mosfets in a buck convert with a frequency of around 31khz in this config down below but wonder how to do this in flowcode with a pic. Please help with details of how to go about this.
- Attachments
-
- Screenshot_20210619-235538_1.png (185.98 KiB) Viewed 1605 times
Last edited by Derrihj on Sat Jun 19, 2021 10:18 pm, edited 1 time in total.
-
- Posts: 348
- Joined: Mon Jul 09, 2018 12:43 pm
- Has thanked: 67 times
- Been thanked: 33 times
- Contact:
Re: Mosfet Driver
Buck Converter
- Attachments
-
- Screenshot_20210620-000821_1.png (232.81 KiB) Viewed 1603 times
-
- Posts: 342
- Joined: Fri Jan 26, 2018 12:30 pm
- Location: South Australia
- Has thanked: 44 times
- Been thanked: 60 times
- Contact:
Re: Mosfet Driver
Hello Derrihj
This is not the answer for your question, but a suggestion from my own experience.
I tried to use Arduino to send PWM signal to Nano, however later I found out the existence of the dedicated PWM controllers (SG3526, UC3842, etc) with build-in protection functions (and a better feedback).
Finally I have changed the schematic by leaving to Arduino the main control of the charging process.
There are two types of charging control -> by voltage and by current.
The mosfet driver I used -> TC4420.
This is not the answer for your question, but a suggestion from my own experience.
I tried to use Arduino to send PWM signal to Nano, however later I found out the existence of the dedicated PWM controllers (SG3526, UC3842, etc) with build-in protection functions (and a better feedback).
Finally I have changed the schematic by leaving to Arduino the main control of the charging process.
There are two types of charging control -> by voltage and by current.
The mosfet driver I used -> TC4420.