Hello,
I'm trying to connect my flowkit to an ECIO-40, which is inserted into a EB061 board.
I have selected Port E, since I have CAN and RF modules connected to port B.
When I select "Go/continue" in the Debug window I get "ICD has failed to communicate with the target".
The LEDs on the Flowkit are flashing slowly.
I have attached a file with the ICD settings.
My Flowcode version is 5.4.
Are there any other settings I need to make?
What I can understand from the manual the ICD is active, but the microcontroller is inpause. how can I start the controller?
Regards
Erik
ECIO and Flowkit
-
Enamul
- Posts: 1772
- Joined: Mon Mar 05, 2012 11:34 pm
- Location: Nottingham, UK
- Has thanked: 271 times
- Been thanked: 814 times
- Contact:
Re: ECIO and Flowkit
Hi
I have moved the topic to general programming as it's not a tip or trick. Thanks Jac
I have moved the topic to general programming as it's not a tip or trick. Thanks Jac
-
kersing
- Valued Contributor
- Posts: 2045
- Joined: Wed Aug 27, 2008 10:31 pm
- Location: Netherlands
- Has thanked: 553 times
- Been thanked: 1081 times
- Contact:
Re: ECIO and Flowkit
“Integrity is doing the right thing, even when no one is watching.”
― C.S. Lewis
― C.S. Lewis