Matrix user forums

Hi,
I am looking to buy a FlowKit for use with my 3rd party development board as ICD.

I will make connections to the single pin ICD lines on the FlowKit PCB.

My question is, what are the signals A0 (Scan0) and A1 (Scan1) on J2 used for ?

Cheers
Stewart

Hello Stewart,

The signals AN0 and AN1 are analogue inputs which can be used with the scope software available from here.

http://www.matrixmultimedia.com/mmforum ... =26&t=7376

Hello Benj,
Thanks for the information.

I was concerned that they might have been some obscure handshaking signals used in ICD.

However, as I don't need them I will ignore them...

Cheers
Stewart