HP488 LCD
Posted: Sun Feb 26, 2012 1:35 pm
Hello,
I'm new to using the PIC processor. I have just purchased the HP488 V3 board to get started on this chip. I have previous experience with the Renesas processors.
I was just wondering, is there a manual for this board as I have not received anything useful with the board. I am struggling to get the LCD working, I have set it up and everything, but the commands don't seem to go to the LCD, the LEDs at the corresponding ports do however light up. I'm not sure how the jumpers are meant to be set either.
Any help would be much appreciated.
Regards,
Ryan
I'm new to using the PIC processor. I have just purchased the HP488 V3 board to get started on this chip. I have previous experience with the Renesas processors.
I was just wondering, is there a manual for this board as I have not received anything useful with the board. I am struggling to get the LCD working, I have set it up and everything, but the commands don't seem to go to the LCD, the LEDs at the corresponding ports do however light up. I'm not sure how the jumpers are meant to be set either.
Any help would be much appreciated.
Regards,
Ryan