Hi,
I am looking to buy a FlowKit for use with my 3rd party development board as ICD.
I will make connections to the single pin ICD lines on the FlowKit PCB.
My question is, what are the signals A0 (Scan0) and A1 (Scan1) on J2 used for ?
Cheers
Stewart
FlowKit signals
-
- Posts: 116
- Joined: Tue Jul 17, 2012 9:34 am
- Been thanked: 18 times
- Contact:
- Benj
- Matrix Staff
- Posts: 15312
- Joined: Mon Oct 16, 2006 10:48 am
- Location: Matrix TS Ltd
- Has thanked: 4803 times
- Been thanked: 4314 times
- Contact:
Re: FlowKit signals
Hello Stewart,
The signals AN0 and AN1 are analogue inputs which can be used with the scope software available from here.
http://www.matrixmultimedia.com/mmforum ... =26&t=7376
The signals AN0 and AN1 are analogue inputs which can be used with the scope software available from here.
http://www.matrixmultimedia.com/mmforum ... =26&t=7376
Regards Ben Rowland - MatrixTSL
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
-
- Posts: 116
- Joined: Tue Jul 17, 2012 9:34 am
- Been thanked: 18 times
- Contact:
Re: FlowKit signals
Hello Benj,
Thanks for the information.
I was concerned that they might have been some obscure handshaking signals used in ICD.
However, as I don't need them I will ignore them...
Cheers
Stewart
Thanks for the information.
I was concerned that they might have been some obscure handshaking signals used in ICD.
However, as I don't need them I will ignore them...
Cheers
Stewart