ESP32 support

For questions and comments on programming in general. And for any items that don't fit into the forums below.

Moderators: Benj, Mods

Post Reply
jadiflow
Flowcode v5 User
Posts: 273
Joined: Thu Apr 17, 2008 9:59 am
Has thanked: 19 times
Been thanked: 16 times
Contact:

ESP32 support

Post by jadiflow »

Hi, getting up to speed with the ESP32 family.
I want to develop hardware with WiFi, USB and Ethernet support.
Espressive has what they call the ESP32 Ethernet board https://docs.espressif.com/projects/esp ... 1-2-layout, which has Ethernet functionality as well as the WROVER WiFi/Bluetooth plugin board.
Flowcode has support for the WROVER module, but I am not sure whether the combination with the Ethernet board is supported.
How would I use that board in FC?

Jan Didden

chipfryer27
Valued Contributor
Valued Contributor
Posts: 618
Joined: Fri Jun 06, 2014 3:53 pm
Has thanked: 184 times
Been thanked: 195 times
Contact:

Re: ESP32 support

Post by chipfryer27 »

Hi

As far as I am aware that particular board is not directly supported. However as ESP support started with v9 it may be better if you post your question in the v9 forum as perhaps someone has used it and can advise better.

Regards

jadiflow
Flowcode v5 User
Posts: 273
Joined: Thu Apr 17, 2008 9:59 am
Has thanked: 19 times
Been thanked: 16 times
Contact:

Re: ESP32 support

Post by jadiflow »

Thanks, but as far as I am aware I did post in the FC9 forum, but I will check.
I started using FC with version 5, so I am always shown as FC5 user ...
Maybe the system automagically slotted me into the FC5 forum, I don't know.

Edit - I see, the FC9 forum is a whole different board section. Thanks for correcting me!

Jan

Post Reply