Matrix user forums

Hallo,

generated a simple flowcode ( intosc with IO, intosc pllenEnable 500 kHz , uint 0x2fec )

Start

Value 255 Output Port C
WAIT 1 s
Value 0 Output Port C
WAIT 1 s

Go Start

F5 simulation is working

At the PIC , all LED's are on , no visible change

What's wrong ?

Hi skammann,
The likely cause will be your configuration settings.
You could have left watchdog enabled for example.
Of course as you have not posted your flowchart there is no way of knowing for sure.
If you attach your flowchart, I will take a look at it for you.

Martin.

Dear Martin,

thank you for your reply, your idea was very good.
Watchdog was enabled , without it's working as requested.

Best regards

Stefan