The compiler does not work !!!

A forums to allow bugs and problems with Flowcode v7 to be reported and resolved.

Moderator: Benj

Post Reply
User avatar
Osta
Posts: 159
Joined: Tue Jul 05, 2016 9:42 am
Been thanked: 13 times
Contact:

The compiler does not work !!!

Post by Osta »

The compiler does not work !!!
This has happened before ! Deleted the project and started again everything was fine .
And here is again stopped work !!! Compiles HEX but this HEX is not working!
After as prescribed TRISE register....
I do not know what to do!!! Delete the project again and start over?
Attachments
MMD.fcfx
This file.
(14.8 KiB) Downloaded 192 times

kersing
Valued Contributor
Valued Contributor
Posts: 2045
Joined: Wed Aug 27, 2008 10:31 pm
Location: Netherlands
Has thanked: 553 times
Been thanked: 1081 times
Contact:

Re: The compiler does not work !!!

Post by kersing »

Could you post the generated message file? (Attach the txt file to your message)
“Integrity is doing the right thing, even when no one is watching.”

― C.S. Lewis

User avatar
Osta
Posts: 159
Joined: Tue Jul 05, 2016 9:42 am
Been thanked: 13 times
Contact:

Re: The compiler does not work !!!

Post by Osta »

I did the right thing?
Attachments
TXT File.txt
(1.54 KiB) Downloaded 169 times

medelec35
Matrix Staff
Posts: 9520
Joined: Sat May 05, 2007 2:27 pm
Location: Northamptonshire, UK
Has thanked: 2585 times
Been thanked: 3815 times
Contact:

Re: The compiler does not work !!!

Post by medelec35 »

The text message you posted is just stating your project has compiled OK.
The Hex file should have been generated.

Martin
Martin

User avatar
Osta
Posts: 159
Joined: Tue Jul 05, 2016 9:42 am
Been thanked: 13 times
Contact:

Re: The compiler does not work !!!

Post by Osta »

Yes, the file is generated, but after programming the project that used to work, now does not work
I do not understand...
I changed nothing.
In the simulator Proteus also stopped working.

EDIT:
I will start this project again
To see the difference...

EDIT2:
I realized where I was wrong!
Thanks for the help !!!
Best regards Osta :)
Last edited by EtsDriver on Sat May 19, 2018 9:03 pm, edited 1 time in total.
Reason: Edited multiple messages into one

Post Reply