I successfully wrote a program using 4 software UARTs. Thank you Matrix. But when I open it, the connections for Tx and Rx
change to a default $PortD.0 and $PortD.1, and I have to re enter the correct lines. Not a biggie, but a nusiance.
Software UART Data Lines
Moderator: Benj
- Benj
- Matrix Staff
- Posts: 15312
- Joined: Mon Oct 16, 2006 10:48 am
- Location: Matrix TS Ltd
- Has thanked: 4803 times
- Been thanked: 4314 times
- Contact:
Re: Software UART Data Lines
Hello,
Thanks for letting us know, I believe this problem has already been fixed and is available from here.
viewtopic.php?f=63&t=19743
Can you have a go and let us know how you get on.
Thanks for letting us know, I believe this problem has already been fixed and is available from here.
viewtopic.php?f=63&t=19743
Can you have a go and let us know how you get on.
Regards Ben Rowland - MatrixTSL
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel