Matrix user forums

Hi Ben,

I've written about this topic in the following post:
http://www.matrixtsl.com/mmforums/viewt ... =2&t=19766
Unfortunately, it did not improve with 7.3.0.7 update, so I'll re-issue this problem.

I would like to use ICT function of FlowKit2.
In the Flowcode 7.3.0.5 or higher version, in the ANALOG section of the ICT function, the inputs can not be activated.
Can not assign FlowKit 2 inputs for analog channels of the PIC24FJ256GA106 microcontroller in this case.

(The number of inputs offered by Flowcode depends for the type of the selected microcontroller.)
In the DIGITAL part, you can assign ports from only a reduced list to the FlowKit 2 Dx inputs.
Is there any medicine for this?

Best Regards,

Lagoda

Hi Lagoda,
Thanks for the post.
I'll raise the issue here.
Leigh

Hello Leigh,

I bought Flowcode 8, but the problem is same as before.
Would you be so kind to fix it.

Lagoda

Oh I'll chase this up

This has now been resolved and will be available in the next V8 release,
but not sure when that we be.

Thanks. I use the Flowcode 7 also. Would be repaired version for this?