Hi Ben,
I've written about this topic in the following post:
http://www.matrixtsl.com/mmforums/viewt ... =2&t=19766
Unfortunately, it did not improve with 7.3.0.7 update, so I'll re-issue this problem.
I would like to use ICT function of FlowKit2.
In the Flowcode 7.3.0.5 or higher version, in the ANALOG section of the ICT function, the inputs can not be activated.
Can not assign FlowKit 2 inputs for analog channels of the PIC24FJ256GA106 microcontroller in this case.
(The number of inputs offered by Flowcode depends for the type of the selected microcontroller.)
In the DIGITAL part, you can assign ports from only a reduced list to the FlowKit 2 Dx inputs.
Is there any medicine for this?
Best Regards,
Lagoda
Port mapping bug in the ICT module.
Moderator: Benj
- LeighM
- Matrix Staff
- Posts: 2178
- Joined: Tue Jan 17, 2012 10:07 am
- Has thanked: 481 times
- Been thanked: 699 times
- Contact:
Re: Port mapping bug in the ICT module.
Hi Lagoda,
Thanks for the post.
I'll raise the issue here.
Leigh
Thanks for the post.
I'll raise the issue here.
Leigh
-
- Posts: 170
- Joined: Fri Jul 15, 2016 9:51 pm
- Has thanked: 69 times
- Been thanked: 61 times
- Contact:
Re: Port mapping bug in the ICT module.
Hello Leigh,
I bought Flowcode 8, but the problem is same as before.
Would you be so kind to fix it.
Lagoda
I bought Flowcode 8, but the problem is same as before.
Would you be so kind to fix it.
Lagoda
- LeighM
- Matrix Staff
- Posts: 2178
- Joined: Tue Jan 17, 2012 10:07 am
- Has thanked: 481 times
- Been thanked: 699 times
- Contact:
Re: Port mapping bug in the ICT module.
This has now been resolved and will be available in the next V8 release,
but not sure when that we be.
but not sure when that we be.
-
- Posts: 170
- Joined: Fri Jul 15, 2016 9:51 pm
- Has thanked: 69 times
- Been thanked: 61 times
- Contact:
Re: Port mapping bug in the ICT module.
Thanks. I use the Flowcode 7 also. Would be repaired version for this?