Page 1 of 1
Analog Component Error
Posted: Fri Nov 17, 2017 11:14 pm
by alanwms
The error below comes up when compiling to hex. The program works fine, and the component pins ARE actually connected. Is there an explanation for this?
- analog Error.jpg (45.07 KiB) Viewed 2947 times
Re: Analog Component Error
Posted: Fri Nov 17, 2017 11:22 pm
by kersing
Please post your flowchart... Debugging these errors is difficult without sufficient information and the flowchart contains a lot of information.
If I had to hazard a guess, you have more analog components added and one of them has unconnected pins.
Re: Analog Component Error
Posted: Mon Nov 20, 2017 5:17 am
by alanwms
Two channels were assigned to An3 (one was flow - which was mine) one of those channels automatically has some "pot_chicken_Pie" name which was confusing. I had added a different one (flow), and subsequently removed pot_chicken_whatsit due to your suggestion. Problem solved.
The help button takes me to a non page so it's learn by fire after switching from 5 to 7.
Thanks
Re: Analog Component Error
Posted: Mon Nov 20, 2017 3:57 pm
by Benj
Hello,
The help button takes me to a non page
Is the link broken or is there something you can suggest we can do to improve the wiki landing page?