Benj wrote:Hello Astro,
Are you trying this in simulation or are you using Ghost hardware and ICT?
In simulation the PWM output is not currently simulated. We only have the PWM component itself which shows the waveform. We could try and generate the PWM waveform in simulation but the timing would likely be off and it may eat up a lot of resources trying to do in software what the PWM hardware does on the micro.
Using ICT and Ghost you should be able to see the PWM signal from the real world hardware in Flowcode.
Thanks Benj for your reply,
just ran it on the EB006V9 board and i can see the pwm trace on
my Rigol scope,so i know that the flowchart is running ok.
Because i could see the trace on the data recorder scope view,
when running a flowchart with a flashing led on RBO, i thought that i was
using scopeview wrong.Now i under stand (i am new to flowcode, i have a lot of learning do.
![Very Happy :D](./images/smilies/icon_biggrin.gif)
)
regards astro1234.