I use the XC16 compiler for some of my projects, so can i use xc16 in Flowcode v7 standard,
is so what settings do i need to set up in the compiler setup.
thanks for looking.
Regards astro1234.
xc16 settings in flowcode v7. ?
Moderator: Benj
-
- Posts: 51
- Joined: Fri Apr 07, 2017 5:51 pm
- Has thanked: 6 times
- Been thanked: 11 times
- Contact:
Re: xc16 settings in flowcode v7. ?
Make sure you change the Microchip compiler version number in the paths denoted below to whatever the compiler versions are on your system. Also copy pic16_C30_comp.bat file from the Flowcode installation directory to the Microchip directory using the install path shown below as a pointer on where to place it.
Microchip Pro xc8
compiler
C:\Program Files (x86)\Microchip\xc8\v1.41\bin\xc8.exe
--chip=$(chip) "$(target).c" --MSGDISABLE=359,1273,1388
linker
$(appdir)tools\DoNothing\DoNothing.exe
--------------------------------------------
Microchip Pro xc16
compiler
C:\Program Files (x86)\Microchip\xc16\v1.31\bin\pic16_C30_comp.bat
"$(target)" "$(outdir)" "$(chip:u)"
linker
$(appdir)compilers\pic16\batchfiles\pic16_C30_link.bat
"$(outdir)$(target)" $(chip:u) $(family)
-------------------------------------------
Microchip Pro xc32
compiler
C:\Program Files (x86)\Microchip\xc32\v1.42\bin\xc32-gcc.exe
-mprocessor=$(chip) -O1 -o "$(srcdir)$(target).out" "$(srcdir)$(target).c"
linker
$(appdir)compilers\pic32\bin\xc32-bin2hex.exe
"$(srcdir)$(target).out"
-------------------------------------------
Microchip Pro xc8
compiler
C:\Program Files (x86)\Microchip\xc8\v1.41\bin\xc8.exe
--chip=$(chip) "$(target).c" --MSGDISABLE=359,1273,1388
linker
$(appdir)tools\DoNothing\DoNothing.exe
--------------------------------------------
Microchip Pro xc16
compiler
C:\Program Files (x86)\Microchip\xc16\v1.31\bin\pic16_C30_comp.bat
"$(target)" "$(outdir)" "$(chip:u)"
linker
$(appdir)compilers\pic16\batchfiles\pic16_C30_link.bat
"$(outdir)$(target)" $(chip:u) $(family)
-------------------------------------------
Microchip Pro xc32
compiler
C:\Program Files (x86)\Microchip\xc32\v1.42\bin\xc32-gcc.exe
-mprocessor=$(chip) -O1 -o "$(srcdir)$(target).out" "$(srcdir)$(target).c"
linker
$(appdir)compilers\pic32\bin\xc32-bin2hex.exe
"$(srcdir)$(target).out"
-------------------------------------------
-
- Posts: 50
- Joined: Mon Apr 10, 2017 12:53 pm
- Has thanked: 39 times
- Been thanked: 13 times
- Contact: