Hello,
When instal C4ARM and running then received a message: Key is not correct.
so what?
Joe
c for arm on WindowsXP-64 and registercode
- Benj
- Matrix Staff
- Posts: 15312
- Joined: Mon Oct 16, 2006 10:48 am
- Location: Matrix TS Ltd
- Has thanked: 4803 times
- Been thanked: 4314 times
- Contact:
Re: c for arm on WindowsXP-64 and registercode
Hello Joe
Atmel has so far not released a driver for the 64-bit operating systems, Is there another non 64-bit machine you can install and use the software with. The course itself should run ok though. You can email me with your serial code if you like and I will test it here on a 32-bit and a 64-bit machine.
Atmel has so far not released a driver for the 64-bit operating systems, Is there another non 64-bit machine you can install and use the software with. The course itself should run ok though. You can email me with your serial code if you like and I will test it here on a 32-bit and a 64-bit machine.
Regards Ben Rowland - MatrixTSL
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel