dspic30f2010
Moderator: Benj
dspic30f2010
I need dspic30f2010 ic 4 pwm control. when i try to add not created hex file getting errors. please give me solution. and is it possible to attach build flowcode with 4 pwm
-
- Posts: 444
- Joined: Tue Apr 15, 2014 4:19 pm
- Location: Kajaani, Finland
- Has thanked: 345 times
- Been thanked: 227 times
- Contact:
Re: dspic30f2010
Hi and welcome to forums!
Could you attach your flowchart to the message so we can investigate better?
I tried to make 4 pwm work on FC V7, and found out the compiler doesnt like it for some reason...
EDIT:
Ill link a post here; V6 case might be same as the V7, so Flowcode does not currently support more than 2 PWM components at one time...
Could you attach your flowchart to the message so we can investigate better?
I tried to make 4 pwm work on FC V7, and found out the compiler doesnt like it for some reason...
EDIT:
Ill link a post here; V6 case might be same as the V7, so Flowcode does not currently support more than 2 PWM components at one time...
Ben wrote:It seems we currently only support the 2 x CCP type PWM on the dsPIC devices.
The other 3/6 PWM are advanced motor control PWM channels which may require a separate component to be created. With the 8-bit PICs I managed to include the advanced PWM using the standard PWM component but with the 30F2010 it looks like it will be tricky to do this.
Ill just keep the good work up!
Re: dspic30f2010
Hi sir,
I have try with depict30f4011 ic that is only 4 channel ccp if. That is supported to 4 pwm but that is very costly for sinewave inverter
I have try with depict30f4011 ic that is only 4 channel ccp if. That is supported to 4 pwm but that is very costly for sinewave inverter