Simulation with two COM ports fails
Moderator: Benj
-
- Valued Contributor
- Posts: 2045
- Joined: Wed Aug 27, 2008 10:31 pm
- Location: Netherlands
- Has thanked: 553 times
- Been thanked: 1081 times
- Contact:
Simulation with two COM ports fails
When adding two components using RS232 and using simulation there are console tabs for two UARTs (COMPort1 and COMPort2). The properties (after exposing full tree) show COMPort1 for both components and the input/output of one of the channels is (randomly?) listed in one of the console windows. Input of the other channel seems to be ignored (GPS component so no output).
“Integrity is doing the right thing, even when no one is watching.”
― C.S. Lewis
― C.S. Lewis
- Benj
- Matrix Staff
- Posts: 15312
- Joined: Mon Oct 16, 2006 10:48 am
- Location: Matrix TS Ltd
- Has thanked: 4803 times
- Been thanked: 4314 times
- Contact:
Re: Simulation with two COM ports fails
Sounds like this is potentially a limitation of the DLL. We should be able to sort it.
I've passed you the files so you can investigate but can also try and lend a hand if your not getting anywhere.
I've passed you the files so you can investigate but can also try and lend a hand if your not getting anywhere.
Regards Ben Rowland - MatrixTSL
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel