Hello Team
I suspect this to be an bug in FC
When i use 10Mhz Crystal with PLL enabled then my clock frequency is 40Mhz which is totally fine for this device its max clock speed is 40MHZ.
however FC does not allow me to enter the 40MHZ it reports a max of 20MHZ is allowed (as in the case of a PIC16)
When I use the bigger brother PIC18F4431 with the same setting FC allows me to enter the 40MHZ
Possible Bug for PIC18F2431
Moderator: Benj
- QMESAR
- Valued Contributor
- Posts: 1287
- Joined: Sun Oct 05, 2014 3:20 pm
- Location: Russia
- Has thanked: 384 times
- Been thanked: 614 times
- Contact:
Possible Bug for PIC18F2431
- Attachments
-
- 2.jpg (29.08 KiB) Viewed 2777 times
https://www.flowcodexchange.com/
Regards QMESAR
Regards QMESAR
-
- Matrix Staff
- Posts: 9520
- Joined: Sat May 05, 2007 2:27 pm
- Location: Northamptonshire, UK
- Has thanked: 2585 times
- Been thanked: 3815 times
- Contact:
Re: Possible Bug for PIC18F2431
Hi QMESAR,
I have attached an unofficial fix so you can enter 40MHz clock speed.
Just place the attached file in: or
Depending on which windows version you have.
Martin
I have attached an unofficial fix so you can enter 40MHz clock speed.
Just place the attached file in:
Code: Select all
C:\Program Files (x86)\Flowcode 6\FCD\PIC
Code: Select all
C:\Program Files\Flowcode 6\FCD\PIC
Martin
- Attachments
-
- 18F2431.fcdx
- (27.3 KiB) Downloaded 154 times
Martin
- QMESAR
- Valued Contributor
- Posts: 1287
- Joined: Sun Oct 05, 2014 3:20 pm
- Location: Russia
- Has thanked: 384 times
- Been thanked: 614 times
- Contact:
Re: Possible Bug for PIC18F2431
Hi Martin
Thank you very much !
Appreciate it, have good time
Thank you very much !
Appreciate it, have good time
https://www.flowcodexchange.com/
Regards QMESAR
Regards QMESAR