I baught an oled display with the chip DSS1306 in spi-mode. After init and placing a number and a line occurs the following:
The number are only lines in a block.
The line is presented in several lines
All lines are displayed with one line spaceing?
In the forum where an older component file, which I tried and the result was a black display.
So have anyone an idea to resolve this situation?
All needed infos are placed on the attached jpg.
GLCD with SSD1306 not working
Moderator: Benj
-
- Posts: 77
- Joined: Wed Jun 22, 2011 3:32 pm
- Has thanked: 17 times
- Been thanked: 11 times
- Contact:
GLCD with SSD1306 not working
- Attachments
-
- Results glcd_SSD1306.jpg
- (123.51 KiB) Downloaded 663 times