Page 1 of 1
version 5 to version 6
Posted: Wed May 28, 2014 8:56 pm
by phil..c
i have just upgraded from V5 to V6 pro. I have tried to import a file I did in version 5 for a 12f675 microcontroller and its got the port inputs/outputs wrong and will not simulate correctly.. I have re tried the program on v5 and all is good. Any idea why it wont work from one version to another. Thank you
Re: version 5 to version 6
Posted: Thu May 29, 2014 11:20 am
by SteveM
Hi Phil,
We'll need to see the troublesome file to be able to give you a clear answer. You could either attach it to a post here, or if you would prefer to keep your project confidential, attach it to a private message to one of the Matrix staff (SteveM, Benj or LeighM). To attach a file, use the 'Upload Attachment' tab below the message entry window - note that the 'Browse' button only sets the file location, you must also click the 'Add the file' button.
Best regards,
Steve.
Re: version 5 to version 6
Posted: Thu May 29, 2014 1:45 pm
by phil..c
no I don't mind attaching the files its only for an led control. as I said it work fine under V5 but not V6. thanks for your help.
Re: version 5 to version 6
Posted: Tue Jun 03, 2014 10:53 am
by Benj
Hello,
It looks like some of the component connections have not imported into v6 correctly. I have fixed the file by hand and this should hopefully now work correctly.
Re: version 5 to version 6
Posted: Tue Jun 03, 2014 4:28 pm
by phil..c
Ok thank you. If this happens again on other files that's what I will do.