Matrix user forums

I am upgrading to flowcode 6 pro from flowcode 5 pro, I have the PIC and the AVR/arduino chip sets. Does anyone have a link or instructions on how to start a fresh install, including the drivers I will need and which directories they would need to be installed in. I am using windows Vista 64 bit. I tried looking on the forum and the Matrix site but could not find any clear A to Z instructions. I am assuming if I do automatic install evrything should install in the appropriate directories ?

Thank you,
Rick Mangu

Hello Rick,

Yes the default locations or a custom location should work fine. The paths are all setup to be relative to the installation so it shouldn't really matter where you put it.

Here is some instructions on how to get up and running with Arduino.

http://www.matrixmultimedia.com/mmforum ... 84&p=52998

Regarding device drivers what hardware are you using?

Hi Benj,
Hardware wise I have ECIO 40P, EB069 wireless lan, Arduino Starter Kit.

Thanks
Rick