Fowcode 6 Install

A collection of posts and articles on getting started in Flowcode v6

Moderator: Benj

Post Reply
RM2012
Posts: 17
Joined: Wed Jul 18, 2012 3:42 pm
Has thanked: 3 times
Contact:

Fowcode 6 Install

Post by RM2012 »

I am upgrading to flowcode 6 pro from flowcode 5 pro, I have the PIC and the AVR/arduino chip sets. Does anyone have a link or instructions on how to start a fresh install, including the drivers I will need and which directories they would need to be installed in. I am using windows Vista 64 bit. I tried looking on the forum and the Matrix site but could not find any clear A to Z instructions. I am assuming if I do automatic install evrything should install in the appropriate directories ?

Thank you,
Rick Mangu

User avatar
Benj
Matrix Staff
Posts: 15312
Joined: Mon Oct 16, 2006 10:48 am
Location: Matrix TS Ltd
Has thanked: 4803 times
Been thanked: 4314 times
Contact:

Re: Fowcode 6 Install

Post by Benj »

Hello Rick,

Yes the default locations or a custom location should work fine. The paths are all setup to be relative to the installation so it shouldn't really matter where you put it.

Here is some instructions on how to get up and running with Arduino.

http://www.matrixmultimedia.com/mmforum ... 84&p=52998

Regarding device drivers what hardware are you using?

RM2012
Posts: 17
Joined: Wed Jul 18, 2012 3:42 pm
Has thanked: 3 times
Contact:

Re: Fowcode 6 Install

Post by RM2012 »

Hi Benj,
Hardware wise I have ECIO 40P, EB069 wireless lan, Arduino Starter Kit.

Thanks
Rick

Post Reply