CAN bus filter selection easier

Please add any feature requests for Flowcode version 6 here

Moderator: Benj

Forum rules
Only feature requests will be considered here. General questions should not be posted in this forum.
Post Reply
EtsDriver
Posts: 444
Joined: Tue Apr 15, 2014 4:19 pm
Location: Kajaani, Finland
Has thanked: 345 times
Been thanked: 227 times
Contact:

CAN bus filter selection easier

Post by EtsDriver »

You had some kind of mask calculator in V4/V5?
CAN solution Teachers notes wrote:25.2.4 The Details dialog
As Masks and Filters are quite complex, so we have included a dialog that displays which Message
ID's will be accepted given the current mask and filter settings for that buffer. To open the Details
dialog click on the Details button on the RX Buffer tabs.


Figure 25.1 The dialog shows the Mask and Filters values, and the Message ID's that each Filter
will accept

If a Filter is not enabled then the text "Filter Disabled" will be shown instead. The Buffer RX1 dialog is
similar to the Buffer RX0 dialog shown above, but with boxes for the four filters on that buffer.
How hard could it be to get it back to the FC6?
Ill just keep the good work up!

User avatar
Benj
Matrix Staff
Posts: 15312
Joined: Mon Oct 16, 2006 10:48 am
Location: Matrix TS Ltd
Has thanked: 4803 times
Been thanked: 4314 times
Contact:

Re: CAN bus filter selection easier

Post by Benj »

Thanks for the suggestion, I have added it to the list.

EtsDriver
Posts: 444
Joined: Tue Apr 15, 2014 4:19 pm
Location: Kajaani, Finland
Has thanked: 345 times
Been thanked: 227 times
Contact:

Re: CAN bus filter selection easier

Post by EtsDriver »

Any news about this? :)
Ill just keep the good work up!

Post Reply