ECCP Module Support

rocket6delta · Post by **rocket6delta** » Thu Sep 12, 2013 8:54 pm

Does Flowcode support ECCP modules for Microchip controllers or plans to do so? I've seen posts on this forum from people in the past regarding this. I would like to request this if possible. Thanks.

Post by **Benj** » Fri Sep 13, 2013 10:20 am

Hello,

Thanks for your request, Do you have any specific devices or functionality in mind?

rocket6delta · Post by **rocket6delta** » Fri Sep 13, 2013 10:20 pm

I'm trying to work with a 18f87k22 chip. I'm wanting to drive (5) 5V dc motors independently. Maybe I can do this with the standard ccp modules? I'm new to this and still figuring out how to do this.
Thanks for your reply.

rocket6delta · Post by **rocket6delta** » Sat Sep 14, 2013 12:22 am

After reading the datasheet for the chip, I think I could use the half-bridge driver mode with the programmable dead band delay feature. I could use the auto shutdown and auto restart features and special event trigger. There are some other feature like programmable polarity and output steering mode but I don't think I could use those.

Thanks

prasha920 · Post by **prasha920** » Wed Apr 30, 2014 3:20 pm

hi,
i am also looking for the same.
i m going to use the controller 16f1936, which is equipped with enhanced pwm, where dead band delay also included.
i just want to know that how those some enhanced features used or controlled through FC4.

thanks n regards
Prashant Kamble.

prasha920 · Post by **prasha920** » Mon Jun 30, 2014 12:16 pm

hi,
rocket6delta, anybody got the idea...?

Matrix user forums

ECCP Module Support

ECCP Module Support

Re: ECCP Module Support

Re: ECCP Module Support

Re: ECCP Module Support

Re: ECCP Module Support

Re: ECCP Module Support