Hi I am trying to get the ESP8266 going with flowcode. Lots of info but where do I start. What Firmware, the flowcode part is it AT commands, LUA. Then some videos shows a chippack. LUA seems good but I would rather use flowcode for all sorts of reasons mainly on Arduino boards. The Flowcode help file mentions property references HTML Page 1 that can be referenced? How.
Sorry for the stupid questions but i have nodemcu, and Xbee Wee units and simply cannot the examples going on any of these boards.
ESP8266
Moderator: Benj
-
- Valued Contributor
- Posts: 2045
- Joined: Wed Aug 27, 2008 10:31 pm
- Location: Netherlands
- Has thanked: 553 times
- Been thanked: 1081 times
- Contact:
Re: ESP8266
The esp component requires the AT firmware to be loaded and the module to be connected to a serial port on of your arduino/controller.
“Integrity is doing the right thing, even when no one is watching.”
― C.S. Lewis
― C.S. Lewis
-
- Posts: 37
- Joined: Tue Sep 03, 2013 8:29 am
- Has thanked: 8 times
- Been thanked: 4 times
- Contact:
Re: ESP8266
Anybody tried the ESP8266 on Arduino UNO or Leonardo I get c
warning: passing argument 3 of 'FCI_SCOPY' discards qualifiers from pointer target type when I compile.
Any idea how to solve this. THX
Any idea how to solve this. THX
-
- Valued Contributor
- Posts: 2045
- Joined: Wed Aug 27, 2008 10:31 pm
- Location: Netherlands
- Has thanked: 553 times
- Been thanked: 1081 times
- Contact:
Re: ESP8266
Those warnings are annoying but can be ignored.
“Integrity is doing the right thing, even when no one is watching.”
― C.S. Lewis
― C.S. Lewis
-
- Posts: 37
- Joined: Tue Sep 03, 2013 8:29 am
- Has thanked: 8 times
- Been thanked: 4 times
- Contact:
Re: ESP8266 Leonardo
Ok thanks I found the problem it is the serial port on the Leonardo I use. It has an XBEE socket and I am plugging a wee ESP8266 in there. The schematic indicates the serial as D+ and D- . Can I change this in Flowcode as it allows only for Channel 1 D3 and D2.