When I change the chip configuaration word(s) (buidl->Project options-> tab configuartion) just by clicking OK and then save the Flowcode. Then after opening the same flowcode the cofigutaions word is lost.
What to do?
Kind regards
Jan Lichtenbelt
Project options lost
Moderator: Benj
-
Jan Lichtenbelt
- Posts: 797
- Joined: Tue Feb 17, 2009 8:35 pm
- Location: Haren GN, the Netherlands
- Has thanked: 128 times
- Been thanked: 264 times
- Contact:
-
JonnyW
- Posts: 1230
- Joined: Fri Oct 29, 2010 9:13 am
- Location: Matrix Multimedia Ltd
- Has thanked: 63 times
- Been thanked: 290 times
- Contact:
Re: Project options lost
Hi. I have not seen this in the latest build - what chip are you using?
Jonny
Jonny
-
Jan Lichtenbelt
- Posts: 797
- Joined: Tue Feb 17, 2009 8:35 pm
- Location: Haren GN, the Netherlands
- Has thanked: 128 times
- Been thanked: 264 times
- Contact:
Re: Project options lost
Dear David,
I use the 16F1847. But also 16F1939. I change e.g. to the internal oscillator, Power up enabled and MCLR disabled.
In the mean time I found the error. The settings are saved correctly. And opening again the flowcode shows the correct configuaration words, but the wrong setting. In my example I saved with internal oscillator, which has bit <2-0> 100 (hex. 4) which you see the 0x984 is correct, but the scheme below does not corresponds with this loaded configuration word.
Kind regards
Jan Lichtenbelt
I use the 16F1847. But also 16F1939. I change e.g. to the internal oscillator, Power up enabled and MCLR disabled.
In the mean time I found the error. The settings are saved correctly. And opening again the flowcode shows the correct configuaration words, but the wrong setting. In my example I saved with internal oscillator, which has bit <2-0> 100 (hex. 4) which you see the 0x984 is correct, but the scheme below does not corresponds with this loaded configuration word.
- ConfigWord.jpg (140.89 KiB) Viewed 3425 times
Jan Lichtenbelt