Flowcode error
Posted: Thu Jan 18, 2007 3:21 am
The following error occurs when trying to configure the PIC 16F88 (USB multiprogrammer) in Flowcode.
"Flowcode could not load one of the component in the file because it is not registered on this machine. Install the necessary components before opening this file"
Currently using version 2.2 Pro.
How do I correct the error?
Thanks,
Jack
"Flowcode could not load one of the component in the file because it is not registered on this machine. Install the necessary components before opening this file"
Currently using version 2.2 Pro.
How do I correct the error?
Thanks,
Jack