flowcode V3 problem
Posted: Mon Dec 18, 2006 10:10 pm
Hi,
I bought an "update" to flowcode professional V3. Installed it from the CD, looked OK to me. I started up, loaded an fcf file that had been compiling and downloading to a PIC 16F88 without any problem under v2 and than....
Flowcode starts a "pre-processor" and I see some dots on the screen for a while, until I finally abort the compilation. Done this with a couple of files, and tried to reset some settings for the 16F88 etc. Didn't help. Pretty annoying experience, the more so since flowcode v2 won't open this (Valuable!) file anymore since apparently V3 has done something to it and V2 says "unexpected file format" and doesn't eat it anymore.
What am I doing wrong, I saw an issue about extremely long compilation times on the forum, I'll try being (even more) patient tomorrow night with this, but for now |I am assuming something is wrong with my installation or so, this is simply not functioning at all it seems to me.
Would welcome any advice, first of all on getting V3 to work, second on how to salvage my earlier V2 files to complie again under V2.
best regards, fransky
I bought an "update" to flowcode professional V3. Installed it from the CD, looked OK to me. I started up, loaded an fcf file that had been compiling and downloading to a PIC 16F88 without any problem under v2 and than....
Flowcode starts a "pre-processor" and I see some dots on the screen for a while, until I finally abort the compilation. Done this with a couple of files, and tried to reset some settings for the 16F88 etc. Didn't help. Pretty annoying experience, the more so since flowcode v2 won't open this (Valuable!) file anymore since apparently V3 has done something to it and V2 says "unexpected file format" and doesn't eat it anymore.
What am I doing wrong, I saw an issue about extremely long compilation times on the forum, I'll try being (even more) patient tomorrow night with this, but for now |I am assuming something is wrong with my installation or so, this is simply not functioning at all it seems to me.
Would welcome any advice, first of all on getting V3 to work, second on how to salvage my earlier V2 files to complie again under V2.
best regards, fransky