Page 1 of 1
Problem with Flowcode
Posted: Tue Jan 08, 2008 8:07 pm
by Henk
Hello there,
I have a problem with Flowcode.
If I sending a program to the Pic 16f870 than the program says >buillding CASM file. En of the end of it I see> Return code=259<.
Can you tell me what the problem is?
Posted: Wed Jan 09, 2008 11:29 am
by Benj
Hello Henk
Please send the program to
support@matrixmultimedia.co.uk and I will take a look for you.
Posted: Wed Jan 09, 2008 7:11 pm
by Henk
.
Hello Ben,
Yesterday it was a ferry bad day because every time I send the program to the pic 16f870 than the program V 3.0 says Building a casm file and the sending stopped.
To day is everything ok.
I think that Flowcode is allricht but my computer have a problem.
I am going to install windows XP again than install flowcode and ppp.
Then I hope that everyting is allricht.
If I have then the same problem again I contact you.
I have another question Which ppp version must I use by Fowcode V 3.2
Regards Henk.
Posted: Thu Jan 10, 2008 10:35 am
by Benj
Hello Henk
With any version of Flowcode it is best to use the most up to date version of PPP. I think this is currently Version 3.9.12.26.
Good luck with your new install.