Page 1 of 1
Unrecognised chip on command line PIC16F631
Posted: Mon Aug 27, 2007 10:17 am
by Rosenbaum
I have a problem with a PIC16F631. It is not possible for me to configure this chip in PPP. If I try it, I get the remark "Unrecognised chip on command line: <PIC16F631>" and there is also no possibility to chose this chip in PPP.
IΒ΄m using:
Flowcode: 3.2.1
PPP: 3.9.12.26
Posted: Tue Aug 28, 2007 9:54 am
by Benj
Hello
Sorry but this PICmicro device is not yet supported by PPP. If you are desperate to use this device then it may be possible to get a patch for PPP which allows this chip by emailing
steve@matrixmultimedia.co.uk However he is very busy so do not expect an immediate responce.
Posted: Tue Aug 28, 2007 11:07 am
by Rosenbaum
Thanks for the answere. Is there another way to configure this chip ? I program the "source code" with Flowcode, then I compile it and put it via Mplab into the chip
Posted: Tue Aug 28, 2007 11:20 am
by Steve
If you are sending the program using MPLAB, you can comment out the appropriate config statements in the ASM file and set the config word(s) up via the "configuration" menu within MPLAB.