run in single steep

For Flowcode users to discuss projects, flowcharts, and any other issues related to Flowcode 2 and 3.

Moderators: Benj, Mods

Post Reply
saschech@gmx.de
Posts: 714
Joined: Wed Jan 31, 2007 12:41 pm
Has thanked: 1 time
Been thanked: 26 times
Contact:
Contact saschech@gmx.de

run in single steep

Post by saschech@gmx.de »

Hallo together

If i work with the eeprom-macro and change data with eeprom-macro (write) the ee-window changedata only after i stop.Is this normal or must i show after execute the eeprom-macro the change?

Please can jou help mi?

Regards wolfgang
Top
User avatar
Benj
Matrix Staff
Posts: 15312
Joined: Mon Oct 16, 2006 10:48 am
Location: Matrix TS Ltd
Has thanked: 4803 times
Been thanked: 4314 times
Contact:
Contact Benj

Post by Benj »

Hello

This is normal im afraid. However if you are reading back values from the EEPROM in simulation then these values will be correct. It is only the values that are shown on the EEPROM component that do not get updated until the simulation has been stopped.
Top
Post Reply

Return to “Flowcode V2 & V3”