Matrix user forums

Ian, Steve,

I have a student who is writing a clock routine that contiains three loops, seconds, minutes and hours. Display is to the LCD. His simulation works but when he tries to compile and download to the PIC he gets the following error.

---------
Flowcode was unable to compile the flowcharts C code due to the following errors:
No compilation error information is available.

If your flowchart contains C code, please review this carefully. If you flowchart contains no C code, or you have thoroughly reviewed the code, contact technical support.
----------

Any ideas?

Jack

Hello

Send me the code and I will see if I can get it working.

Ben,

Could you tell me how to attach a Flowcode file in a reply?

Thanks,

Jack

Hello Jack,

Please email the FCF and the C file to Ben at our "support" email address. We have not set this forum up to allow attachments yet.

Hello, i have the same problem and i dont have c code in my flow chart. Then, i check very carefully my flow chart and i don't see any problem. When i tray to compile, it put the following message.

Flowcode was unable to compile the flowcharts C code due to the following errors:
No compilation error information is available.

If your flowchart contains C code, please review this carefully. If you flowchart contains no C code, or you have thoroughly reviewed the code, contact technical support.

Any idea. Thank you

RAMTEC,

Please email the file to support@matrixmultimedia.co.uk