Hello. Could I ask you?
Can I interwork simulation and hardware in flowcode5?
Does simulation and hardware run at the same time?
If they are available, can I use it in ICD mode?
Could you send me the manual of HP299-00-1?
Yours faithfully.
ICD mode
Moderator: Benj
- Benj
- Matrix Staff
- Posts: 15312
- Joined: Mon Oct 16, 2006 10:48 am
- Location: Matrix TS Ltd
- Has thanked: 4803 times
- Been thanked: 4314 times
- Contact:
Re: ICD mode
Hello,
No the ICD in v5 will not allow the simulation to also run.
Flowcode v6 does not allow this directly but does allow real world communications such as COM ports, MIDI, USB, Ethernet etc to interact with the simulation.
The HP299 datasheet is available from here: http://www.matrixtsl.com/resources/getr ... .php?id=78
No the ICD in v5 will not allow the simulation to also run.
Flowcode v6 does not allow this directly but does allow real world communications such as COM ports, MIDI, USB, Ethernet etc to interact with the simulation.
The HP299 datasheet is available from here: http://www.matrixtsl.com/resources/getr ... .php?id=78
Regards Ben Rowland - MatrixTSL
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel