Page 1 of 1
new "tab group"
Posted: Sat Aug 11, 2012 6:22 pm
by saschech@gmx.de
Hello
First time I work with "new Tab Group"....After close and new start V5,I show only one tab group(also after save all....
Regards Wolfgang
Re: new "tab group"
Posted: Sun Aug 12, 2012 8:00 pm
by Sparkoids
Hi Wolfgang,
I got this and found the answer is to display each macro "as Flocode" from the menu bar until all are as your picture.
Then you "Save As" and use a different filename and next time you open it they are all available....
James :-}
Re: new "tab group"
Posted: Mon Aug 13, 2012 4:08 pm
by saschech@gmx.de
Hi,Sparkoids
I have save as xyz001 close and open again ..... with out success.
I show only one tab-group (test with v5 for pic and beta v5 for dspic)
Regards Wolfgang
Re: new "tab group"
Posted: Mon Aug 13, 2012 6:20 pm
by Sparkoids
Sorry Wolfgang it works for me :-{
No idea I'm afraid....
Re: new "tab group"
Posted: Wed Aug 15, 2012 7:21 am
by saschech@gmx.de
Hi,mm-team
Is the reaction of the Tab-Group (new groups after new start closed) requested?
because to navigate is very unmanageable for my (only change on the mark top and down....)
Regards Wolfgang