Hi !
I'm trying Xbee from maxtream with the lastest Flowcode release.
How can I set the baudrate ?
I had a look into your C code component and I think the macro only configure the Xbee module in 9600 bauds with a 19660800 crystal
That's right ?
Thank you
Mathy
Zigbee and Baudrate
Moderator: Benj
- Benj
- Matrix Staff
- Posts: 15312
- Joined: Mon Oct 16, 2006 10:48 am
- Location: Matrix TS Ltd
- Has thanked: 4803 times
- Been thanked: 4314 times
- Contact:
Re: Zigbee and Baudrate
Hello Mathy
The Zigbee component automatically sets up the baud rate for you at 9600 based on your crystal speed. You just have to connect the XBEE module to the microcontroller UART via a voltage level shifter if you are using a 5V system.
The Zigbee component automatically sets up the baud rate for you at 9600 based on your crystal speed. You just have to connect the XBEE module to the microcontroller UART via a voltage level shifter if you are using a 5V system.
Regards Ben Rowland - MatrixTSL
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel