Matrix user forums

Hi guys

I want to build a circiut in tina design soft but can not figure out where to connect the wires on the AD620 as there are no pin numbers on any of the pins?
Please advice on how to build a circiut using spice models in tina or how to asign pin numbers.

Hello,

For Tina based support please can you go to the support section on the Designsoft website and register your problem there. The Designsoft staff are much more experienced with the product and will be able to give superior product support.

http://www.tina.com/English/tina/start. ... echsup&id=